Technical & Troubleshooting
Technical & Troubleshooting
Latest discussions
My pulse oximeter shows a low reading but the patient is talking normally.
Created by Ishaan Tiwari (1 month ago)
Check for 'signal interference.' Cold hands, dark nail polish, or bright overhead lights can cause false low readings. Try a different finger or a different person. If the patient shows no signs of di...
Technical & Troubleshooting
0
0
Why is the BiPAP 'Auto-On' feature not working?
Created by Sara Qureshi (1 month ago)
This feature depends on detecting your first breath. If you have a large mask leak or are a very shallow breather, the machine may not 'feel' you. Adjust the mask or turn the feature off and use the '...
Technical & Troubleshooting
0
0
The suction jar is full. How do I empty it?
Created by Rahul Joshi (1 month ago)
Turn off the machine. Carefully disconnect the tubes. Open the lid and empty the contents into the toilet. Wash the jar with soap and water, then disinfect with a diluted bleach solution before reasse...
Technical & Troubleshooting
0
0
How do I change the flow on my oxygen regulator (cylinder)?
Created by Noor Shaikh (1 month ago)
Turn the dial on the regulator until the desired number (LPM) aligns with the indicator mark. Ensure you hear the 'click' at each setting to confirm the flow is engaged.
Technical & Troubleshooting
0
0
My patient monitor is showing a 'Flat Line' ECG but the patient is fine.
Created by Riya Pandey (1 month ago)
Check the electrodes. They usually dry out or fall off when the patient moves. Clean the skin with an alcohol swab and apply fresh electrodes. Ensure the lead wires are firmly snapped onto the electro...
Technical & Troubleshooting
0
0
Why does my oxygen concentrator smell like 'burnt dust'?
Created by Arjun Bansal (1 month ago)
This happens if the machine hasn't been used for a while and dust has settled on the internal components. It should go away after 10 minutes. If the smell persists or you see smoke, unplug it immediat...
Technical & Troubleshooting
0
0
How do I clean a 'reusable' nebulizer kit?
Created by Gurpreet Singh (1 month ago)
Wash in warm soapy water after every use. Once a day, soak in a 1:3 vinegar-to-water solution for 30 minutes, rinse, and air dry. Replace the kit every 3-6 months.
Technical & Troubleshooting
0
0
The wheelchair footrests are in the way. Can I remove them?
Created by Krishna Mishra (1 month ago)
Yes. Most footrests have a release lever that allows them to swing to the side or be lifted off completely for easier transfers into and out of the chair.
Technical & Troubleshooting
0
0
The patient monitor is beeping constantly but vitals are normal.
Created by Sana Shaikh (1 month ago)
Check the 'Alarm Limits' settings. Someone may have set the heart rate or SpO2 limits too narrow. Adjust the limits to the range recommended by your doctor so the alarm only triggers when there is a r...
Technical & Troubleshooting
0
0
My wheelchair feels like it's pulling to one side.
Created by Harpreet Kaur (1 month ago)
Check the tire pressure. If one tire is flatter than the other, it will pull. Also, ensure there is no hair or debris caught in the front caster wheel bearings.
Technical & Troubleshooting
0
0
Showing 10 of 60 discussions
